Rain Roof For Walkin Cooler

Available to buy here for a freestanding or butted unit.

Rain roof for walkin cooler.

A rubber roof membrane or rain roof on an outdoor walk in cooler or freezer is intended to prevent water from leaking to the inside of the box. Seal all protruding rough edges such as screw heads rivets etc. Slope foam installation for a walk in consists of the tapered foam and the vapor barrier material. With dura last approved caulk.

Then screw a plate at each end of flap. Allow 6 of vinyl to lap over each of the three sides. Click here for additional information. These roofing systems are typically installed after the walk in unit has been constructed or built on site.

Fill out this form to receive a quote on a polyvinyl membrane rain roof and all necessary components. Kolpak flat roof cap optional vinyl roof membrane use when locating walk in boxes outside and exposed to the weather priced per square foot features. Depending on the size of your walk in cooler or freezer rubber roof membranes can cost approximately 200 for a small unit and up to 900 for a larger unit. Priced per square foot.

Must be added at time of walk in purchase. No products were found matching your selection. Install evaporator coil prior to rain roof installation and silicone caulking around the carriage bolt heads to avoid perforating the rain roof. This material is very strong and is often used in harsh environments.

Keep placing until your end up with a screw and flap every 12. Installation of the membrane will incur additional costs as will the annual maintenance and repairs. This will prevent any chance of penetrating or wearing a hole in the membrane roof cap. Carefully unroll vinyl material until vinyl flap falls into position.

Rain roofs are important for outdoor walk ins to prevent water damage. Rubber roof membrane is made from a rubber compound called epdm ethylene propylene diene monomer. Place vinyl roofing material with flaps underneath on to of walk in across narrow end. Oct 15 2014 duro last rain roof for 6x6 outdoor walk in coolers and freezers.

The purpose of the rubber roof membrane is to cover the roof of your walk in cooler or freezer in outdoor applications. Check the rooftop of the walk in and remove any foreign matter.